Industrial Electrical
Industrial Electrical Services and Equipment Power Solutions
Civitas Electrical brings field experience, technical knowledge and careful project planning to industrial equipment, power distribution and facility electrical work.
What we do
Power distribution
- Three-phase power circuits
- Conduit and feeder installations
- Panel and distribution modifications
- Facility electrical upgrades
Equipment power
- Equipment power connections
- Motors and disconnects
- VFD power installations
- Production-equipment circuits
Support and diagnostics
- Industrial troubleshooting
- Control-power support
- Power-quality and harmonic evaluations
- Scheduled shutdown work
Equipment power planning
Industrial equipment installs go wrong when the power requirements are confirmed last. We start from the nameplate and the installation manual, verify voltage, phase and full-load current, then confirm the feeder, overcurrent protection and disconnecting means against the available service.
Three-phase system work
Three-phase branch circuits and feeders are installed with attention to conductor sizing, voltage drop over the actual run, rotation, and terminations that will hold up under load and vibration.
Feeder and disconnect installations
Feeders, junction boxes, disconnecting means and equipment terminations are installed with supports, routing and working clearances that reflect how the space is actually used and maintained.
Facility modifications
Layout changes, added equipment and relocated machinery usually require distribution changes. We evaluate the existing panel capacity and available spaces before committing to a scope.
Troubleshooting methodology
We work from the symptom to the measurement rather than from the symptom to a parts swap: confirm the reported condition, take readings under load where it is safe to do so, isolate the failure point and document what was found.
Coordination and shutdown planning
Work that requires de-energizing production equipment is planned in advance with the facility contact — scope, sequence, isolation, expected duration and the condition the equipment will be returned in.
Scope of capability
Civitas Electrical takes on industrial work it can complete correctly. We do not represent capability in engineering design, PLC or controls programming, medium-voltage work or hazardous-location classification. If a project requires those, we will say so.
Frequently asked questions
Not covered here? Send the details and we will respond as soon as possible.
Do you install power for production equipment?
Yes. Equipment power connections, three-phase branch circuits, disconnects and motor circuits are core industrial work for us.
Do you perform PLC or controls programming?
No. We install and support control power and equipment power. Programming, engineering design and medium-voltage work are outside the capability we represent.
Can you work during a scheduled shutdown?
Yes. Shutdown work is planned in advance with the facility contact so the scope, isolation and expected duration are agreed before the equipment comes down.
Do you handle power-quality complaints?
We can evaluate power-quality and harmonic symptoms, take measurements and identify contributing conditions or recommend a specialist where a deeper study is warranted.
Are you available as a subcontractor?
Yes. Send the project details and we will confirm whether the scope is a fit before quoting.
Discuss an Industrial Electrical Project
Send the equipment details, drawings or facility scope and Civitas Electrical will review the request and confirm scope fit.